Electronic Cigarette Battery Skin Replacement Guide

Many people using electronic cigarettes may encounter the issue of battery skin peeling, which is often overlooked initially. However, over time, it can lead to electrical leakage. Therefore, it is essential to find a solution for this battery skin peeling phenomenon! Today, we will teach you how to give your damaged battery a new "skin" layer!

Step 1:
Purchase battery skins online (here we will use Green Giant battery skins). Completely remove the damaged battery skin and stretch the Green Giant skin open. Insert the battery into the new skin.

Step 2:
Adjust the battery vertically to ensure that the excess length of the battery skin is evenly distributed at the top and bottom.

Step 3:
Take a heat gun or hairdryer and adjust it to blow hot air mode. Cover the battery skin and start blowing the air, starting with the negative pole (bottom) of the battery.

Step 4:
Continue blowing the hot air, now blowing the positive pole (top) of the battery. The battery skin will shrink inward due to the heat. Remember to hold the small ring in place at the positive pole while blowing. In the demonstration, we use a fingernail to hold it down. The temperature of the air should not be too high. Once the shrinking is complete, stop blowing and ensure that the insulation ring is in place.

Step 5:
Stand the battery upright or place it on a flat surface and blow hot air on the side of the battery.

Step 6:
You're all done! The battery now looks brand new.

By following these six steps, you can effectively give your electronic cigarette battery a fresh new skin. Remember, maintenance is crucial for electronic cigarette usage, so be sure to perform the necessary maintenance tasks to prolong the lifespan of your electronic cigarette.